Lighting Shop Cable System Online Ordering at Factory Direct Prices

Cable Bracket Mounting Instructions

Cable light

1. Locate your mounting points and drill a hole large enough for the toggle (A) to slide through.

2. Insert the metal end of the toggle (A) through the hole.

3. Slide the plastic disc towards the wall while gently pulling back on the ring.

4. When the disc is firm against the wall, bend the plastic at the wall and snap the wings off.

Cable light

5. Insert the screw (B) through the bracket base (C) and into the hole in the disc. Hand thread the screw into the toggle.

6. Tighten the bracket base screw (C) to the toggle (A).

7. Insert the bracket shaft (D) into the base (B) and tighten it firmly.

8. NOTE: Secure both cables to one wall by following steps 9 & 10. DO NOT TIGHTEN THE TURN BUCKLES YET. Then pull the cable tight towards the opposite bracket and cut the cable 1 inch short of the bracket as shown in Photo #8. Wrap the cable with tape and cut through the tape.

Cable light

9. Insert the end of the cable through the small hole in the end of the turn-buckle neck (E). Tighten the cable collar (F) to the cable with the hex key provided.

10. Thread the turn-buckle neck (E) onto the turn-buckle shaft (G).

11. While holding the turn-buckle neck (E), turn the shaft (G) counter clock-wise with a screw driver inserted through the hole in the side of the shaft. Do this with all brackets until the cable is tight.


	1. Locate your mounting points and drill a hole large enough for the toggle (A) to slide through.
	2. Insert the metal end of the toggle (A) through the hole.
	3. Slide the plastic disc towards the wall while gently pulling back on the ring.
	4. When the disc is firm against the wall, bend the plastic at the wall and snap the wings off.


5. Insert the screw (B) through the bracket base (C) and into the hole in the disc. Hand thread the screw into the toggle.
6. Tighten the bracket base screw (C) to the toggle (A).
7. Insert the bracket shaft (D) into the base (B) and tighten it firmly.
8. NOTE: Secure both cables to one wall by following steps 9 & 10. DO NOT TIGHTEN THE TURN BUCKLES YET. Then pull the cable tight towards the opposite bracket and cut the cable 1 inch short of the bracket as shown in Photo #8. Wrap the cable with tape and cut through the tape.


9. Insert the end of the cable through the small hole in the end of the turn-buckle neck (E). Tighten the cable collar (F) to the cable with the hex key provided.
10. Thread the turn-buckle neck (E) onto the turn-buckle shaft (G).
11. While holding the turn-buckle neck (E), turn the shaft (G) counter clock-wise with a screw driver inserted through the hole in the side of the shaft. Do this with all brackets until the cable is tight.